Products | Teledyne Monitor Labs

Exceptional stability is achieved with the use of an optical shutter to compensate for PMT drift and a reference detector to correct for changes in UV lamp intensity. A hydrocarbon ‘kicker’ and advanced optical design combine to prevent inaccuracies due to interferents.

All T Series instruments offer an advanced color display, capacitive touch screen, intuitive user interface, flexible I/O, and built-in data acquisition capability. All instrument set up, control and access to stored data and diagnostic information is available through the front panel using NumaView™ Software, or via RS232, Ethernet, or USB com ports, either locally or by remote connection using the included NumaView™ Remote PC Software. NumaView™ Remote PC Software allows for a remote connection with virtual interface and data downloading capability to analyzers operating NumaView™ Software.

The Model T100 comes with NumaView™ Software. NumaView™ Remote PC Software allows for a remote connection with virtual interface and data downloading capability to analyzers operating NumaView™ Software.

The following table provides a list of items that need regular maintenance to ensure your product remains in good working condition.

Maintenance

ITEM	ACTION	FREQUENCY	CAL CHECK	MANUAL SECTION
¹Particulate filter	Change particle filter	Weekly	No	10.3.1
Verify test functions	Review and evaluate	Weekly	No	10.2; Appendix C in manual
Zero/span check	Evaluate offset and slope	Weekly	--	9.3, 9.6, 9.9
¹Zero/span calibration	Zero and span calibration	Every 3 months	--	9.2, 9.4, 9.5, 9.7, 9.8
¹External zero air scrubber (optional)	Exchange chemical	Every 3 months	No	10.3.3
¹Perform flow check	Check Flow	Every 6 Months	No	10.3.7
Internal IZS Permeation Tube	Replace	Annually	Yes	10.3.2
Perform pneumatic leak check	Verify Leak Tight	Annually or after repairs involving pneumatics	Yes	10.3.6
²Pump diaphragm	Replace	Annually	Yes	Refer to diaphragm kit instructions
Calibrate UV Lamp Output	Perform lAMP CAL	Prior to zero/span calibration or PMT hardware calibration	--	5.9.6 & 11.7.2.5
³PMT sensor hardware calibration	Low-level hardware calibration	On PMT/ preamp changes if 0.7 < slope or slope >1.3	Yes	11.7.2.8
¹Sample chamber optics	Clean chamber, windows and filters	As necessary	Yes	11.7.2.2 & 11.7.2.3
¹Critical flow orifice & sintered filters	Replace	As necessary	Yes	10.3.4
1 These items are required to maintain full warranty; all other items are strongly recommended. 2 A pump rebuild kit is available from Teledyne API's Technical Support, including all instructions and required parts. 3 Replace desiccant bags each time the inspection plate for the sensor assembly is removed.